Where is the main relay on a 1993 Honda Accord?

The main relay is located just right above the hood release, inside the dash panel bolted to the left kick panel with a bolt that will fit a 10 mm socket….

How much is a 1993 Honda Accord worth?

1993 Honda Accord Value ” $121-$2,609 | Edmunds.

How do you test a Honda Ignition Control Module?

Turn on the ignition. Attach one lead of the multimeter to the black/yellow wire, and ground the other lead to a nearby piece of metal. The multimeter should give a reading of about 12 volts. If the voltage of this wire is correct, test the white/blue and yellow/green wires.

What would cause an ignition control module to fail?

The cause of an ignition control module failure is often associated with age and damage from heat buildup. The correction for this issue becomes the replacement of the failed component.

How do you know if your ignition control module is bad?

Symptoms of a Bad or Failing Electronic Spark Control

Will a car start with a bad ignition control module?

Stalling: A failing ignition module can occasionally prevent the engine from getting spark, causing it to stall. 4. Car won’t start: An engine needs four basic things to run: fuel,compression, spark and exhaust. If the ignition module has failed completely, the vehicle won’t get spark and won’t start.

What are the symptoms of a bad igniter?

Symptoms of a Bad or Failing Ignition Ignitor

What is igniter example?

There are several types of igniters. Examples include furnace igniters, forced heater igniters, igniters for pellet stove systems, gas igniters, and remote igniters. Gas igniters are engineered to light all fuels. Remote igniters send a signal to the igniter that then lights the fuel in a furnace.

How do you test a 22re igniter?

Push a needle or pin through the top left wire in the igniter connector. Connect the voltmeter’s red lead to the pin and the black lead to any good ground, preferably on the engine. This test will work with the voltmeter only if the engine will not start.

How do you test a distributor igniter?

If you want to check the ignitor, disconnect ir from the coil and put a test light at the coil wires. Crank the engine, you should have a blining light if the ignitor works.

Can I replace an ignition coil myself?

You may see the ‘Service Engine’ light come on and the car might stall or not start at all. You can replace a failing ignition coil fairly easily at home, but remember that you’re dealing with high voltages so must disconnect your battery before you start.

Begin typing your search term above and press enter to search. Press ESC to cancel.